EdilKamin MYA ECO, Installation, Use And Maintenance Manual, Page: 14 / 24

- 14
-
ENGLISH
INSTRUCTIONS FOR USE
Filling the cochlea.
The first time you use the product, or should the tank be completely emptied of pellets, to fill the coclea press both keys “+”
and “–” on the remote control at the same time, holding for a few seconds. As you release the keys, the display should show the
wording “LOAD”. This should be carried out before ignition if the stove has stopped due to having run out of pellets, at the end of
operation to empty the combustion pot before turning.
It is quite normal for some pellets to remain, that the cochlea cannot suction.
Automatic igniting.
With the stove on stand-by, press and hold the key , on the remote control for 2 seconds. This will start-up the
ignition procedure, showing the wording “START”. At the same time, a countdown in seconds begins (from 1020 to 0).
Ignition is not at a preset time, however: its duration is automatically shortened if the board reports that certain tests have
been passed. The flame appears after about 5 minutes.
Manual igniting.
Temperatures of below 3°C will not allow the electrical resistance to heat sufficiently. In this case, or should the
resistance be temporarily out of action, Diavolina® type fire-starters can be used.
Insert a piece of lit Diavolina into the combustion chamber, close the door and press the remote control.
POWER REGULATION
• Remote control manual operation
With the stove working, press the key “M” on the remote control once. The display will show the word “POWER P”.
(specifying the power at which the insert is working). Press the keys “+” or “–” to increase or decrease the insert’s
working power (from “POWER P1” to “POWER P5”).
• Remote control automatic operation
Press key “A” to switch to automatic operation, adjusting the temperature desired for the room (use the “+” and “–” keys
to set the temperature from 5°C to 35°C, and the stove will regulate working power required to reach the temperature set.
If a temperature below that of the room is set, the insert will stay on “POWER P1”.
Turning off
With the stove running, press and hold the key rom the remote control for 2 seconds. The turn-off procedure will begin,
showing a countdown on the display from 9 to 0 (for a total of 10 minutes).
The turn-off phase involves:
• Interruption of pellet supply
• Maximum ventilation.
• Smoke expulsion motor.
Never pull the plug out whilst the device is still in the process of turning off.
OPERATIONS THAT CAN ONLY BE CARRIED OUT BY REMOTE CONTROL
Clock regulation
Press and hold the key “M” for 2 seconds to access the “Clock” menu. This allows you to set the internal electronic board
clock. By then pressing the key “M”, the following data appears in sequence and can be regulated:
day, month, year, hour, minutes, day of the week.
The wording “SAVE??” will appear for confirmation with “M”. This will allow you to check that the operations performed are
correct, prior to completion (the wording “SAVE” will then be shown on the display).