EdilKamin LOU, Installation, Use And Maintenance Manual, Page: 21 / 125

- 21
-
ENGLISH
CHARACTERISTICS
N.B.
1) keep in mind that external devices can cause interference to the operation of the circuit board.
2) warning: activity on live components, maintenance and/or checks must be carried out by qualifi ed personnel.
(before carrying out any maintenance, disconnect the appliance from the mains electricity)
The above data are indicative and are those resulting during certifi cation on the part of the notifi ed body.
EDILKAMIN s.p.a. reserves the right to change the products at its discretion without notice.
SAFETY DEVICES
• THERMOCOUPLE:
Placed at the smoke outlet to detect the temperature.
Turns the stove on and off and controls its operation based on defi ned parameters.
• VACUUM GAUGE:
Positioned on the smoke extractor, which detects the vacuum value (compared to the installation environment) in the combustion
chamber.
• SAFETY THERMOSTAT:
Trips when the temperature inside the stove is too high. It stops pellet loading, causing the stove to go out.
• SAFETY PRESSURE SWITCH:
This is activated if the vacuum inside the combustion chamber is insuffi cient for it to function correctly.
THERMO TECHNICAL CHARACTERISTICS according to EN 14785
Nominal power Reduced power
Heat input (burnt) 9 2,5 kW
Heat output 8 2,4 kW
Yield / Effi ciency 93 95,1 %
Emissions CO 13% O2 0,013 0,059 %
Fume temperature 129 63 °C
Fuel consumption 1,9 0,5 kg/h
Hopper capacity 24 kg
Autonomy 11 42 hours
Heatable volume * 210 m
3
Smoke outlet pipe diameter (male) 80 mm
Air intake pipe diameter (male) 40 mm
Weight including packaging 200 kg
TECHNICAL DATA FOR THE DIMENSIONING OF THE FLUE
Nominal power Reduced power
Heat output 8 2,4 kW
Temperature of fumes on exit from the discharge pipe 200 110 °C
Minimum draught 12 10 Pa
Fume fl ow capacity 5,8 3,2 g/s
Classifi cation of combustion chamber according to DIBt FB 22 FC
52x
-
* The heatable room dimensions are calculated on the basis of home insulation in compliance with Italian law 10/91, and subse-
quent changes together with an expected heat output of 33 Kcal/m³ per hour.
ELECTRICAL CHARACTERISTICS
Power supply 230 Vac +/- 10% 50 Hz
On/off switch Yes
Average power consumption 100 W
Power consumption during ignition 400 W
Remote control frequency Radio waves 2,4 GHz
Protection on mains power supply* (see page 20) T2A, 250 Vac, 5x20 Fuse
Protection on electronic circuit board T2A, 250 Vac, 5x20 Fuse