12
HOW TO SETUP THE ENDEAVOR FOR
CLEANING CARPET OR UPHOLSTERY:
1. Plug in power cords as per instructions on page 8.
2. Make sure you are on 2 circuits.
3. Connect your solution and vacuum hoses to ma-
chine and accessories.
4. Fill the machine with water. See page 10 for auto fill
instructions.
5. Prime the pump as per instructions on page 10.
6. Adjust the pressure to between 100-500psi. See in-
structions and limitations for adjusting pressure on
page 11.
7. See heater operating instructions on page 11 if you
would like to use heat.
8. Prespray the carpet or fabric as necessary.
9. Turn on the vacuum motor.
10. Spray on the backstroke and do a dry stroke when
pushing forward.
11. Overlap your previous path slightly when you pull
back.
12. Monitor the levels in the recovery tank and empty
as necessary. Use defoamer to ensure your vacuum
motor does not take in fluid
HOW TO SETUP THE ENDEAVOR FOR
TILE AND GROUT:
1. Plug in power cords as per instructions on page 8.
2. Make sure you are on 2 circuits.
3. Connect your solution and vacuum hoses to ma-
chine and accessories.
4. Fill the machine with water. See page 10 for auto fill
instrcutions.
5. Prime the pump as per instructions on page 10.
6. Adjust the pressure to between 500-1100psi. See
instructions and limitations for adjusting pressure on
page 11.
7. Prespray the tile and grout surface to be cleaned.
8. Turn on the vacuum motor.
9. Spray and extract using the REVOLUTION in a side
to side motion.
10. Monitor the levels in the recovery tank and empty
as necessary. Use defoamer to ensure your vacuum
motor does not take in fluid.
MOUNTING THE OPTIONAL 991RS AC-
CESSORY CHEMICAL INJECTOR SYSTEM
(NOT INCLUDED):
If you have purchased a 991RS Chemical Injector System
for your ENDEAVOR. Follow the detailed instructions
in the 991RS manual to install onto the ENDEAVOR
body.
FRONT
REAR