3-14
Starmux IV
0023786_REV_C
Figure 3-7: Starmux IV Rear Panel FSK SYNC Connector
3.5
Activating the Unit
WARNING!
Never power up the Starmux IV with the tow cable
disconnected from the tow vehicle. The electric shock is great and severe
enough to cause serious injury or death. This also applies to post-
recovery, as disconnecting the towfish while the power is still on could
result in bodily injury or death.
To activate the Starmux IV Digital Link System:
1.
Turn
ON
the computer and launch the Discover application.
2.
Turn on the line power switch on the rear panel of the Starmux IV Digital Link. This switch can be
left in the
ON
position at all times if desired.
3.
Turn
ON
the power switch on the front panel.
4.
The PWR light should illuminate immediately. The Fish PWR indicator light will illuminate a few
moments afterward. The LAN indicator light will flash continuously to indicate network activity.
The LINK indicator light will flash until a reliable communications link with the Towfish is
established and then illuminate continuously when the link is completed. Also, the
NET Radio
Indicator Tab, in the lower control panel of the Discover application UI, should display:
when the link is fully established and recognized by Discover software
FSK SYNC Connector
