8-61
Figure 8-15: Rebooting Sonar from the Main Screen
8.
Plug the device into COM 1.
9.
Click
Misc.
at the top of the Sonar screen, as shown in
, then
Serial Port Information.
10.
Check
COM1
and set the correct baud rate for that device using the dropdown menu, shown with
a blue arrow in
. When the correct baud rate is set, the State should say
OK,
and
Errors
should not be increasing, as shown circled in green in
. The correct data string should
also be scrolling in the lower part of the window, as shown by the green arrow,
Summary of Contents for 6205S
