5-62
2050-DSS SIDE SCAN AND SUB-BOTTOM SYSTEM
0024048_REV_A
4.
Note the installed roll position of the sub-bottom transducer endcap and any cabling
configurations necessary for re-installation
5.
Using the flathead screwdriver, unthread the worm clamp screw releasing the worm clamps from
the vertically installed transducer and [4] transducer mounting brackets. Remove [2] loose
worm/hose clamps.
6.
Carefully lift the transducer from the towfish.
Installation Instructions:
1.
Carefully place the transducer
between the forward mounts in the
interior of the vehicle.
2.
Reinstall the two worm/hose clamps
over the transducer mounts and
transducer body. One should be
higher than the other and not
overlapping.
Tighten
with a
screwdriver until snug.
3.
Plug the cable back into the sub-
bottom transducer or endcap.
5.8
Operating System Restoration
The following section outlines the procedures for backing up and restoring the system drive.
CAUTION!
All data will be lost upon restoring the system to factory
settings. Be sure to backup all data before performing the procedure
below.
1.
Ensure that the topside is off.
2.
Insert USB3 flash drive in a blue USB3 port.
3.
Start topside and be prepared to press the F
⋆⋆
key when prompted:
a.
If the topside is rack mount, press F11.
b.
If the topside is a laptop, press F12.
Figure 5-9: 2050-DSS Sub Bottom Transducer Clamp and
Mount Orientations
