13
4b. Remove the door axis (1), Switch (2), and Decorative nail (3) from the door. Then to rotate
door at 180 degree. Assemble the door axis. Door switch and decorative nail to the relevant
place on door.
5. Align the glass door to the designated position making sure that the door shaft enters
the door hole at the left upper corner of the glass door. Install the lower hinge
supporter at the left lower corner of the glass door.
6. Install the two screws that are used to connect the left lower hinge with the glass door
and tighten them before the door is leveled.
Removing and Installing Decorative Plugs
Follow the instructions below to remove the decorative plugs from the door.
1. Open the door and carefully pull the door gasket from the top left corner until you have
exposed the two holes which correspond with the decorative plugs. Note: A small
Flathead screwdriver is required.
Important: Before you begin, unplug the refrigerator.