Edge PresencePlus P4, User Manual

Page: 40 / 182

32
P/N 120413
01/05
Getting Started PresencePLUS ® P4 EDGE
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Main Menu Toolbar
Use the Main Menu toolbar to navigate between the Sensor options. Proceeding from left to right, the buttons in the Main Menu
toolbar step through the process of creating and controlling an inspection. Each button is explained in the illustration below and
in the table that follows.
For more information about navigating through options, see Section 4, Getting Started beginning on page 25.
------------------------------------------------------------------------------------------
Main Menu Toolbar Layout
--------------------------
----------------------------------
The following table describes the screen associated with each button in the Main Menu.
--------------------------------------------------------------
Inspection Screens
Setup Set up the Sensor, lens, trigger, and lighting to acquire images. Create a reference image to be used later.
Tools Add tools to an inspection. Build the tools from scratch, or load tools from a previous inspection file saved on the Sensor
or on a PC.
Teach Teach the Sensor good products. This screen automatically configures the parameters chosen in the Tools screen.
Run Choose which inspection file the Sensor will capture, and view the results of the inspection.
System-Wide Screens
System Set up the discrete inputs and outputs and communication configuration. This screen also has the Sensor diagnostic
tools.
Save Name the current inspection files, and save them to the Sensor or a PC for future use.
Help Call up the Help window or the About window.
Teach good parts
Set up I/O and communications
Name and save inspections
Access online help
Add tools to an inspection
Begin an inspection
Create a reference image
Setup Flow