Edge PresencePlus P4, User Manual

Page: 36 / 182

28
P/N 120413
01/05
Getting Started PresencePLUS ® P4 EDGE
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
-----------------------------------------------------
4. Start the software by double-clicking the program icon, or choosing in the
Programs menu.
Upon startup, the program detects whether a Sensor is connected and displays either the Setup screen or the Run screen.
Setting Up Hardware Parameters
If the Sensor is being run for the first time, or if changes have been made to the hardware, then hardware parameters may need
to be set or modified:
1. Click on System in the Main Menu toolbar.
2. Configure the Trigger parameter according to the trigger device being used.
For this example, the QS18V6ND (NPN output) is the trigger device, so NPN is selected.
3. Configure the four discrete inputs/outputs.
4. If a strobed light source is being triggered by the Sensor, set the strobe trigger options.
5. If the Product Select line is being used, configure the Product Select and Product Change lines.
6. Click on
Setup in the Main Menu toolbar, select the Trigger tab, and configure the remaining parameters:
- Edge type
- Minimum pulse width
- Trigger delay
Building an Inspection
The automatic screen sequence starts with the Setup screen, which results from the first button ( Setup ) in the Main Menu
toolbar. Subsequent screens are shown below in the Main Menu toolbar layout.
---------------------------------------------------------------------------------------
Main Menu Toolbar Buttons in Left-to-Right Task Order
--------------------------------------------------------------
Click on the Setup , Tools , Teach , and Run buttons to advance to each screen.
Setup Flow