Edge PresencePlus P4, User Manual

Page: 19 / 182

01/05
P/N 120413
11
User’s Manual Installation
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Hardware Installation
Before installing any hardware, read Warnings and Cautions on page i.
---------------------------------
Mounting the Sensor
Mount the Sensor securely. Optional Banner mounting brackets for PresencePLUS P4 Sensors are available. See Right-Angle
Sensor Mounting Bracket (shown on page 153) and In-Line Sensor Mounting Bracket (shown on page 155) in Section 15,
Dimensions, Specifications, and Parts .
Cable Bend Relief
Allow at least 75 mm (3
"
) clearance at the rear of the Sensor for cable bend relief.
Mounting Hardware
The following mounting hardware is supplied with all brackets:
•
Four M3 x 0.5 x 6 mm socket head cap screws
•
Four medium split lock washers
•
Four flat washers
•
Short-arm hex key wrench
----------------------------------
Mounting the Light Source
The light source must be securely mounted. Any movement in the light source during an inspection could affect inspection
performance.
-------------------------------------------------
-------------------------------------------------------------
The Sensor alone will operate properly with input voltage of 10–30V dc; however, if a light
source is powered by the Sensor, input voltage must be 24V dc ± 10%.
CAUTION