Edge PresencePlus P4, User Manual

Page: 109 / 182

01/05
P/N 120413
101
User’s Manual Communication Tool Setup
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Data can be sent through 11 different communication connections: one connector for the serial connection, and 10 sockets (1 to
10) through the Ethernet connector.
The 10 Ethernet sockets are comprised of the Sensor IP address and port number. The table below lists the default Ethernet
socket addresses:
-----------------------------------------------------------------------------------------------
The serial port is the RS-232 connector (Pins 1 and 11) on the Sensor. The default settings for the serial port are listed in the
table below.
-----------------------------------------------
For more information about configuring the Ethernet and Serial connections, see Communication Tab (in Section 12, System
Setup ) on page 139.
---------------------------------------------------------------------------
C. Format the ASCII String
Use this section to select delimiters, enable labels, and define a Start and/or End string.
Format Options
Socket Default IP Address Port
1 192.168.0.1 20,000
2 192.168.0.1 20,001
3 192.168.0.1 20,002
4 192.168.0.1 20,003
5 192.168.0.1 20,004
6 192.168.0.1 20,005
7 192.168.0.1 20,006
8 192.168.0.1 20,007
9 192.168.0.1 20,008
10 192.168.0.1 20,009
Attribute Default Setting
Baud Rate 115200
Data Bits 8
Parity None
Stop Bit 1
Flow Control None
Choose a delimiter type.
Check this box to add the
names for data being sent.