Version 0716 1.0
EDGE E3-X SSD – Quick Start Guide
Help getting started with your E3-X Solid State Drive
Introduction
Thank you for purchasing the EDGE E3-XSSD! This guide is designedto give you basic information on installing and
using the SSD, as well assome precautions to adhere to.It is important to be familiar with the environment in which
you plan toinstall the SSD in before getting started. Disassembling and reassemblingcovers, lids, bezels, and other
items may be required forinstallation. Please consult your system’s user manual or contact an ITprofessional for
assistance if you are unsure about the install process.
Additional accessories such as brackets or trays may be required toproperly install your SSD. EDGE offers various
SSD install kitsdesignedto make cloning your old hard drive data to the SSD simple. Pleasevisit
www.EDGEMemory.com to learn more.
System Requirements
A computer with a SATA interface connector
An available SATA port on the computer
An available SATA data cable (for some desktops)
Precautions
Ensure all power sources, including the wall power adapter and battery, are disconnected from your
system before installing
Do not expose the SSD to extreme temperatures or sunlight
Do not touch the gold SATA connectors of the SSD
Be conscious of static electricity—wear a wrist strap while installing to minimize risk of damage it can
cause to the SSD
Installation
Your installation experience will vary depending on the type of laptop or desktop you install theSSD into—refer to
your system’s user manual while installing. Below are some general directions that may help while installing:
1.
Ensure all power sources, including the wall power adapter and battery, are disconnected from your
system.
2.
Disassemble your computer’s casing and locate the original hard drive or SSD.
3.
Remove the old drive and replace with the EDGE SSD. If the old drive has any hardware attached to it,
remove it and attach to the SSD (or SSD bracket if using in a desktop) in the same manner.
4.
After the install is complete, reassemble the computer to its original state and restore power.
5.
Power on the system and ensure that the system’s BIOS recognizes the EDGE SSD. Note: You will need to
manually format the SSD before use if you plan to use it as a secondary storage drive (see “formatting”
section for more details).
