Edge-Core ES4524M-PoE, Management Manual, Page: 542 / 560

Command Line Interface
4-272
4
ping
This command sends ICMP echo request packets to another node on the network.
Syntax
ping host [ count count ][ size size ]
• host - IP address of the host.
• count - Number of packets to send. (Range: 1-16)
• size - Number of bytes in a packet. (Range: 32-512)
The actual packet size will be eight bytes larger than the size specified
because the router adds header information.
Default Setting
count: 5
size: 32
Command Mode
Normal Exec, Privileged Exec
Command Usage
• Use the ping command to see if another site on the network can be reached.
• The following are some results of the
ping command:
- Normal response - The normal response occurs in one to ten seconds,
depending on network traffic.
- Destination does not respond - If the host does not respond, a “timeout”
appears in ten seconds.
- Destination unreachable - The gateway for this destination indicates that
the destination is unreachable.
- Network or host unreachable - The gateway found no corresponding entry
in the route table.
• Press <Esc> to stop pinging.
Example
Related Commands
interface (4-135)
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5 seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#