Edge-Core ES4524M-PoE, Management Manual, Page: 459 / 560

VLAN Commands
4-189
4
show spanning-tree mst configuration
This command shows the configuration of the multiple spanning tree.
Command Mode
Privileged Exec
Example
VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Console#show spanning-tree mst configuration
MSTP Configuration Information
--------------------------------------------------------------
Configuration Name: R&D
Revision Level: 0
Instance VLANs
--------------------------------------------------------------
0 2-4094
1 1
Console#
Table 4-1 VLAN Commands
Command Groups Function Page
GVRP and Bridge Extension Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
4-190
Editing VLAN Groups Sets up VLAN groups, including name, VID and state 4-194
Configuring VLAN
Interfaces
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
4-196
Displaying VLAN
Information
Displays VLAN groups, status, port members, and MAC addresses 4-202
Configuring Private VLANs Configures private VLANs, including uplink and downlink ports 4-203
Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol 4-208