Edge-Core ES3510MA-DC, Management Manual, Page: 778 / 1098

C
HAPTER
32
| Address Table Commands
– 778 –
E
XAMPLE
Console(config)#mac-address-table aging-time 100
Console(config)#
mac-address-table
static
This command maps a static address to a destination port in a VLAN. Use
the no form to remove an address.
S
YNTAX
mac-address-table static mac-address interface interface
vlan vlan-id [ action ]
no mac-address-table static mac-address vlan vlan-id
mac-address - MAC address.
interface
ethernet unit / port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
vlan-id - VLAN ID (Range: 1-4093)
action -
delete-on-reset - Assignment lasts until the switch is reset.
permanent - Assignment is permanent.
D
EFAULT
S
ETTING
No static addresses are defined. The default mode is permanent .
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
The static address for a host device can be assigned to a specific port
within a specific VLAN. Use this command to add static addresses to the
MAC Address Table. Static addresses have the following characteristics:
◆
Static addresses will not be removed from the address table when a
given interface link is down.
◆
Static addresses are bound to the assigned interface and will not be
moved. When a static address is seen on another interface, the address
will be ignored and will not be written to the address table.
◆
A static address cannot be learned on another port until the address is
removed with the no form of this command.