Edge-Core ES3510MA-DC, Management Manual, Page: 770 / 1098

C
HAPTER
31
| Automatic Traffic Control Commands
– 770 –
auto-traffic-control
alarm-fire-threshold
This command sets the upper threshold for ingress traffic beyond which a
storm control response is triggered after the apply timer expires. Use the
no form to restore the default setting.
S
YNTAX
auto-traffic-control { broadcast | multicast }
alarm-fire-threshold threshold
no auto-traffic-control { broadcast | multicast }
alarm-fire-threshold
broadcast
- Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
threshold - The upper threshold for ingress traffic beyond which a
storm control response is triggered after the apply timer expires.
(Range: 1-255 kilo-packets per second seconds)
D
EFAULT
S
ETTING
128 kilo-packets per seconds
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆
Once the upper threshold is exceeded, a trap message may be sent if
configured by the snmp-server enable port-traps atc broadcast-alarm-
fire command or snmp-server enable port-traps atc multicast-alarm-
fire command.
◆
After the upper threshold is exceeded, the control timer must first
expire as configured by the auto-traffic-control apply-timer command
before a control response is triggered if configured by the auto-traffic-
control action command.
E
XAMPLE
This example sets the trigger threshold for automatic storm control for
broadcast traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast alarm-fire-threshold 255
Console(config-if)#