Edge-Core ES3510MA-DC, Management Manual, Page: 742 / 1098

C
HAPTER
28
| Link Aggregation Commands
– 742 –
channel-group
This command adds a port to a trunk. Use the no form to remove a port
from a trunk.
S
YNTAX
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-5)
D
EFAULT
S
ETTING
The current port will be added to this trunk.
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆
When configuring static trunks, the switches must comply with the
Cisco EtherChannel standard.
◆
Use no channel-group to remove a port group from a trunk.
◆
Use no interface port-channel to remove a trunk from the switch.
E
XAMPLE
The following example creates trunk 1 and then adds port 10:
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/10
Console(config-if)#channel-group 1
Console(config-if)#
lacp
This command enables 802.3ad Link Aggregation Control Protocol (LACP)
for the current interface. Use the no form to disable it.
S
YNTAX
[ no ] lacp
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆
The ports on both ends of an LACP trunk must be configured for full
duplex, either by forced mode or auto-negotiation.