Edge-Core ES3510MA-DC, Management Manual, Page: 471 / 1098

C
HAPTER
18
| Multicast Filtering
Filtering and Throttling IGMP Groups
– 471 –
E
NABLING
IGMP
F
ILTERING AND
T
HROTTLING
Use the Multicast > IGMP Snooping > Filter (Configure General) page to
enable IGMP filtering and throttling globally on the switch.
CLI R
EFERENCES
◆
"ip igmp filter (Global Configuration)" on page 916
P
ARAMETERS
These parameters are displayed:
◆
IGMP Filter Status – Enables IGMP filtering and throttling globally for
the switch. (Default: Disabled)
W
EB
I
NTERFACE
To enable IGMP filtering and throttling on the switch:
1.
Click Multicast, IGMP Snooping, Filter.
2.
Select Configure General from the Step list.
3.
Enable IGMP Filter Status.
4.
Click Apply.
Figure 287: Enabling IGMP Filtering and Throttling
C
ONFIGURING
IGMP
F
ILTER
P
ROFILES
Use the Multicast > IGMP Snooping > Filter (Configure Profile – Add) page
to create an IGMP profile and set its access mode. Then use the (Add
Multicast Group Range) page to configure the multicast groups to filter.
CLI R
EFERENCES
◆
"IGMP Filtering and Throttling" on page 915
C
OMMAND
U
SAGE
Specify a range of multicast groups by entering a start and end IP address;
or specify a single multicast group by entering the same IP address for the
start and end of the range.