Edge-Core ECS4660-28F, Management Manual, Page: 969 / 2020

C
HAPTER
24
| System Management Commands
Precision Time Protocol
– 969 –
ptp log-min-delay-
request-interval
This command sets the delay request message transmit interval. Use the
no form to restore the default setting.
S
YNTAX
ptp log-min-delay-request-interval interval-value
no ptp log-min-delay-request-interval
interval-value – The minimum interval between delay request
messages sent by a slave clock to a specific port on the master
clock. (Range: 0-5 in log base 2)
D
EFAULT
S
ETTING
0 (1 second)
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
◆
The log base 2 settings equate to the following values:
■
0 – 1 packet every second
■
1 – 1 packet every 2 seconds
■
2 – 1 packet every 4 seconds
■
3 – 1 packet every 8 seconds
■
4 – 1 packet every 16 seconds
■
5 – 1 packet every 32 seconds
◆
This value is determined and advertised by a master clock based on its
ability to process delay request message traffic.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ptp log-min-delay-request-interval 1
Console(config-if)#
ptp log-min-pdelay-
request-interval
This command sets the peer delay request message transmit interval. Use
the no form to restore the default setting.
S
YNTAX
ptp log-min-pdelay-request-interval interval-value
no ptp log-min-pdelay-request-interval
interval-value – The minimum interval between peer delay request
messages used to measure the link delay between two clock ports
implementing the peer-to-peer delay mechanism. (Range: 0-5 in
log base 2)