Edge-Core ECS4660-28F, Management Manual, Page: 938 / 2020

C
HAPTER
24
| System Management Commands
Event Logging
– 938 –
show log
This command displays the log messages stored in local memory.
S
YNTAX
show log { flash | ram }
flash - Event history stored in flash memory (i.e., permanent
memory).
ram - Event history stored in temporary RAM (i.e., memory flushed
on power reset).
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
◆
All log messages are retained in RAM and Flash after a warm restart
(i.e., power is reset through the command interface).
◆
All log messages are retained in Flash and purged from RAM after a
cold restart (i.e., power is turned off and then on through the power
source).
E
XAMPLE
The following example shows the event message stored in RAM.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#
show logging
This command displays the configuration settings for logging messages to
local switch memory, to an SMTP event handler, or to a remote syslog
server.
S
YNTAX
show logging { flash | ram | sendmail | trap }
flash - Displays settings for storing event messages in flash
memory (i.e., permanent memory).
ram - Displays settings for storing event messages in temporary
RAM (i.e., memory flushed on power reset).
sendmail - Displays settings for the SMTP event handler
( page 943 ).