Edge-Core ECS4660-28F, Management Manual, Page: 859 / 2020

C
HAPTER
21
| Multicast Routing
Configuring PIMv6 for IPv6
– 859 –
length is less than 32, then only the first portion of the hash is used,
and a single RP will be defined for multiple groups. (Range: 0-32;
Default: 10)
◆
Priority – Priority used by the candidate bootstrap router in the
election process. The BSR candidate with the largest priority is
preferred. If the priority values are the same, the candidate with the
larger IP address is elected to be the BSR. Setting the priority to zero
means that this router is not eligible to server as the BSR. At least one
router in the PIM6-SM domain must be set to a value greater than zero.
(Range: 0-255; Default: 0)
W
EB
I
NTERFACE
To configure the switch as a BSR candidate:
1.
Click Routing Protocol, PIM6, PIM6-SM.
2.
Select BSR Candidate from the Step list.
3.
Specify the VLAN interface for which this router is bidding to become
the BSR, the hash mask length that will subsequently be used for RP
selection if this router is selected as the BSR, and the priority for BSR
selection.
4.
Click Apply.
Figure 541: Configuring a PIM6-SM BSR Candidate
C
ONFIGURING
A
PIM6 S
TATIC
R
ENDEZVOUS
P
OINT
Use the Routing Protocol > PIM6 > SM (RP Address) page to configure a
static address as the Rendezvous Point (RP) for a particular multicast
group.
CLI R
EFERENCES
◆
"ipv6 pim rp-address" on page 1964
C
OMMAND
U
SAGE
◆ The router will act as an RP for all multicast groups in the local PIM6-SM
domain if no groups are specified. A static RP can either be configured
for the whole multicast group range FF00::/8, or for specific group
ranges.