Edge-Core ECS4660-28F, Management Manual, Page: 586 / 2020

C
HAPTER
14
| Basic Administration Protocols
OAM Configuration
– 586 –
CLI R
EFERENCES
◆
"OAM Commands" on page 1603
P
ARAMETERS
These parameters are displayed:
◆ Port – Port identifier. (Range: 1-28)
◆ Admin Status – Enables or disables OAM functions.
(Default: Disabled)
◆ Operation State – Shows the operational state between the local and
remote OAM devices. This value is always “disabled” if OAM is disabled
on the local interface.
◆ Mode – Sets the OAM operation mode. (Default: Active)
■
Active – All OAM functions are enabled.
■
Passive – All OAM functions are enabled, except for OAM discovery,
sending variable request OAMPDUs, and sending loopback control
OAMPDUs.
Table 38: OAM Operation State
State Description
Disabled OAM is disabled on this interface via the OAM Admin Status.
Link Fault The link has detected a fault or the interface is not operational.
Passive Wait This value is returned only by OAM entities in passive mode and
indicates the OAM entity is waiting to see if the peer device is
OAM capable.
Active Send Local This value is used by active mode devices and indicates the
OAM entity is actively trying to discover whether the peer has
OAM capability but has not yet made that determination.
Send Local And Remote The local OAM entity has discovered the peer but has not yet
accepted or rejected the configuration of the peer.
Send Local And Remote
OK
OAM peering is allowed by the local device.
OAM Peering Locally
Rejected
The local OAM entity rejects the peering.
OAM Peering Remotely
Rejected
The remote OAM entity rejects the peering.
Operational When the local OAM entity learns that both it and the remote
OAM entity have accepted the peering, the state moves to this
state.
Non Oper Half Duplex This state is returned whenever Ethernet OAM is enabled but
the interface is in half-duplex operation.