Edge-Core ECS4660-28F, Management Manual, Page: 454 / 2020

C
HAPTER
14
| Basic Administration Protocols
Configuring Event Logging
– 454 –
C
ONFIGURING
E
VENT
L
OGGING
The switch allows you to control the logging of error messages, including
the type of events that are recorded in switch memory, logging to a remote
System Log (syslog) server, and displays a list of recent event messages.
S
YSTEM
L
OG
C
ONFIGURATION
Use the Administration > Log > System (Configure Global) page to enable
or disable event logging, and specify which levels are logged to RAM or
flash memory.
Severe error messages that are logged to flash memory are permanently
stored in the switch to assist in troubleshooting network problems. Up to
4096 log entries can be stored in the flash memory, with the oldest entries
being overwritten first when the available log memory (256 kilobytes) has
been exceeded.
The System Logs page allows you to configure and limit system messages
that are logged to flash or RAM memory. The default is for event levels 0 to
3 to be logged to flash and levels 0 to 7 to be logged to RAM.
CLI R
EFERENCES
◆
"Event Logging" on page 933
P
ARAMETERS
These parameters are displayed:
◆
System Log Status – Enables/disables the logging of debug or error
messages to the logging process. (Default: Enabled)
◆
Flash Level – Limits log messages saved to the switch’s permanent
flash memory for all levels up to the specified level. For example, if
level 3 is specified, all messages from level 0 to level 3 will be logged to
flash. (Range: 0-7, Default: 3)
Table 27: Logging Levels
Level Severity Name Description
7 Debug Debugging messages
6 Informational Informational messages only
5 Notice Normal but significant condition, such as cold
start
4 Warning Warning conditions (e.g., return false,
unexpected return)
3 Error Error conditions (e.g., invalid input, default used)
2 Critical Critical conditions (e.g., memory allocation, or
free memory error - resource exhausted)
1 Alert Immediate action needed
0 Emergency System unusable
* There are only Level 2, 5 and 6 error messages for the current firmware release.