Edge-Core ECS4660-28F, Management Manual, Page: 220 / 2020

C
HAPTER
5
| Interface Configuration
Traffic Segmentation
– 220 –
3.
Mark the Status check box, and set the required uplink-to-uplink mode.
4.
Click Apply.
Figure 64: Enabling Traffic Segmentation
C
ONFIGURING
U
PLINK
AND
D
OWNLINK
P
ORTS
Use the Interface > Traffic Segmentation (Configure Session) page to
assign the downlink and uplink ports to use in the segmented group. Ports
designated as downlink ports can not communicate with any other ports on
the switch except for the uplink ports. Uplink ports can communicate with
any other ports on the switch and with any designated downlink ports.
CLI R
EFERENCES
◆
"Configuring Port-based Traffic Segmentation" on page 1157
C
OMMAND
U
SAGE
◆
When traffic segmentation is enabled, the forwarding state for the
uplink and downlink ports assigned to different client sessions is shown
below.
◆
When traffic segmentation is disabled, all ports operate in normal
forwarding mode based on the settings specified by other functions
such as VLANs and spanning tree protocol.
◆
A port cannot be configured in both an uplink and downlink list.
Table 11: Traffic Segmentation Forwarding
Destination
Source
Session #1
Downlinks
Session #1
Uplinks
Session #2
Downlinks
Session #2
Uplinks
Normal
Ports
Session #1
Downlink Ports
Blocking Forwarding Blocking Blocking Blocking
Session #1
Uplink Ports
Forwarding Forwarding Blocking Blocking/
Forwarding *
* The forwarding state for uplink-to-uplink ports is configured on the Configure
Global page (see page 219 ).
Forwarding
Session #2
Downlink Ports
Blocking Blocking Blocking Forwarding Blocking
Session #2
Uplink Ports
Blocking Blocking/
Forwarding
*
Forwarding Forwarding Forwarding
Normal Ports Forwarding Forwarding Forwarding Forwarding Forwarding