Edge-Core ECS4660-28F, Management Manual, Page: 1959 / 2020

C
HAPTER
52
| Multicast Routing Commands
PIM Multicast Routing
– 1959 –
PIM6-DM Commands
ipv6 pim
graft-retry-interval
This command configures the time to wait for a Graft acknowledgement
before resending a Graft. Use the no form to restore the default value.
S
YNTAX
ipv6 pim graft-retry-interval seconds
no ipv6 pim graft-retry-interval
seconds - The time before resending a Graft.
(Range: 1-10 seconds)
D
EFAULT
S
ETTING
3 seconds
C
OMMAND
M
ODE
Interface Configuration (VLAN)
C
OMMAND
U
SAGE
A graft message is sent by a router to cancel a prune state. When a router
receives a graft message, it must respond with an graft acknowledgement
message. If this acknowledgement message is lost, the router that sent
the graft message will resend it a number of times (as defined by the ipv6
pim max-graft-retries command).
E
XAMPLE
Console(config-if)#ipv6 pim graft-retry-interval 9
Console(config-if)#
R
ELATED
C
OMMANDS
ipv6 pim override-interval (1955)
ipv6 pim propagation-delay (1956)
DR
The designated PIM6-SM router. If multicast hosts are directly
connected to the LAN, then only one of these routers is elected as
the DR, and acts on behalf of these hosts, sending periodic Join/
Prune messages toward a group-specific RP for each group.
Table 289: show ipv6 pim neighbor - display description (Continued)
Field Description