Edge-Core ECS4660-28F, Management Manual, Page: 1634 / 2020

C
HAPTER
48
| DHCP Commands
DHCP Server
– 1634 –
ip dhcp pool
This command configures a DHCP address pool and enter DHCP Pool
Configuration mode. Use the no form to remove the address pool.
S
YNTAX
[ no ] ip dhcp pool name
name - A string or integer. (Range: 1-8 characters)
D
EFAULT
S
ETTING
DHCP address pools are not configured.
C
OMMAND
M
ODE
Global Configuration
U
SAGE
G
UIDELINES
◆
After executing this command, the switch changes to DHCP Pool
Configuration mode, identified by the (config-dhcp)# prompt.
◆
From this mode, first configure address pools for the network interfaces
(using the network command). You can also manually bind an address
to a specific client (with the host command) if required. You can
configure up to 8 network address pools, and up to 32 manually bound
host address pools (i.e., listing one host address per pool). However,
note that any address specified in a host command must fall within the
range of a configured network address pool.
E
XAMPLE
Console(config)#ip dhcp pool R&D
Console(config-dhcp)#
R
ELATED
C
OMMANDS
network (1641)
host (1638)
service dhcp
This command enables the DHCP server on this switch. Use the no form to
disable the DHCP server.
S
YNTAX
[ no ] service dhcp
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Global Configuration