Edge-Core ECS4660-28F, Management Manual, Page: 1307 / 2020

C
HAPTER
39
| ERPS Commands
– 1307 –
7.
Enable an ERPS ring: Before an ERPS ring can work, it must be enabled
using the
enable command. When configuration is completed and the
ring enabled, R-APS messages will start flowing in the control VLAN,
and normal traffic will begin to flow in the data VLANs. To stop a ring, it
can be disabled on any node using the no enable command.
8.
Display ERPS status information: Use the show erps command to
display general ERPS status information or detailed ERPS status
information for a specific ring.
erps
This command enables ERPS on the switch. Use the no form to disable this
feature.
S
YNTAX
[ no ] erps
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
ERPS must be enabled globally on the switch before it can enabled on an
ERPS ring using the enable command.
E
XAMPLE
Console(config)#erps
Console(config)#
R
ELATED
C
OMMANDS
enable (1309)
erps domain
This command creates an ERPS ring and enters ERPS configuration mode
for the specified domain. Use the no form to delete a ring.
S
YNTAX
[ no ] erps domain ring-name [ id ring-id ]
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
ring-id - ERPS ring identifier used in R-APS messages.
(Range: 1-255)
D
EFAULT
S
ETTING
None