Edge-Core ECS4660-28F, Management Manual, Page: 1083 / 2020

C
HAPTER
28
| Authentication Commands
PPPoE Intermediate Agent
– 1083 –
E
XAMPLE
Console(config)#pppoe intermediate-agent format-type access-node-identifier
billibong
Console(config)#
pppoe
intermediate-agent
port-enable
This command enables the PPPoE IA on an interface. Use the no form to
disable this feature.
S
YNTAX
[ no ] pppoe intermediate-agent port-enable
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
PPPoE IA must also be enabled globally on the switch for this command to
tack effect.
E
XAMPLE
Console(config)#int ethernet 1/5
Console(config-if)#pppoe intermediate-agent port-enable
Console(config-if)#
pppoe
intermediate-agent
port-format-type
This command sets the circuit-id or remote-id for an interface. Use the no
form to restore the default settings.
S
YNTAX
pppoe intermediate-agent port-format-type { circuit-id |
remote-id } id-string
circuit-id - String identifying the circuit identifier (or interface) on
this switch to which the user is connected. (Range: 1-10 ASCII
characters)
remote-id - String identifying the remote identifier (or interface)
on this switch to which the user is connected. (Range: 1-63 ASCII
characters)
D
EFAULT
S
ETTING
circuit-id: unit/port:vlan-id or 0/trunk-id:vlan-id
remote-id: port MAC address
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)