Edge-Core ECS4120-28F, Reference Manual, Page: 699 / 938

Chapter 24
| Multicast Filtering Commands
MVR for IPv4
– 699 –
mvr
This command enables Multicast VLAN Registration (MVR) globally on the switch.
Use the
no form of this command to globally disable MVR.
Syntax
[ no ] mvr
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If MVR
must be configured for an IGMP version 1 host, the multicast groups must be
statically assigned using the
mvr vlan group command.
Example
The following example enables MVR globally.
Console(config)#mvr
Console(config)#
mvr associated-profile
This command binds the MVR group addresses specified in a profile to an MVR
domain. Use the
no form of this command to remove the binding.
Syntax
[ no ] mvr domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR group
addresses. (Range: 1-21 characters)
show mvr
associated-profile Shows the profiles bound the specified domain PE
show mvr interface Shows MVR settings for interfaces attached to the MVR
VLAN PE
show mvr members Shows information about the current number of entries in
the forwarding database, or detailed information about a
specific multicast address PE
show mvr profile Shows all configured MVR profiles PE
show mvr statistics Shows MVR protocol statistics for the specified interface PE
Table 138: Multicast VLAN Registration for IPv4 Commands
(Continued)
Command Function Mode