Edge-Core ECS4120-28F, Reference Manual, Page: 669 / 938

Chapter 24
| Multicast Filtering Commands
IGMP Filtering and Throttling
– 669 –
Example
This example shows how to enable IGMP Authentication on all of the switch’s
Ethernet interfaces.
Console(config)#interface ethernet 1/1-28
Console(config-if)#ip igmp authentication
Console#
Related Commands
show ip igmp authentication
ip igmp filter
(Interface Configuration)
This command assigns an IGMP filtering profile to an interface on the switch. Use
the
no form to remove a profile from an interface.
Syntax
[ no ] ip igmp filter profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
◆
The IGMP filtering profile must first be created with the ip igmp profile
command before being able to assign it to an interface.
◆
Only one profile can be assigned to an interface.
◆
A profile can also be assigned to a trunk interface. When ports are configured as
trunk members, the trunk uses the filtering profile assigned to the first port
member in the trunk.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#
NAS_PORT 5 User Port Number
FRAMED_IP_ADDRESS 8 Multicast Group ID
Table 135: IGMP Authentication RADIUS Attribute Value Pairs
(Continued)
Attribute Name AVP Type Entry