Edge-Core ECS4120-28F, Reference Manual, Page: 507 / 938

Chapter 19
| Spanning Tree Commands
– 507 –
Example
Console(config-mstp)#revision 1
Console(config-mstp)#
Related Commands
name (506)
spanning-tree
bpdu-filter
This command allows you to avoid transmitting BPDUs on configured edge ports
that are connected to end nodes. Use the
no form to disable this feature.
Syntax
[ no ] spanning-tree bpdu-filter
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆
This command stops all Bridge Protocol Data Units (BPDUs) from being
transmitted on configured edge ports to save CPU processing time. This
function is designed to work in conjunction with edge ports which should only
connect end stations to the switch, and therefore do not need to process
BPDUs. However, note that if a trunking port connected to another switch or
bridging device is mistakenly configured as an edge port, and BPDU filtering is
enabled on this port, this might cause a loop in the spanning tree.
◆
BPDU filter can only be configured on an interface if the edge port attribute is
not disabled (that is, if edge port is set to enabled or auto with the
spanning-
tree edge-port command).
Example
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree edge-port
Console(config-if)#spanning-tree bpdu-filter
Console(config-if)#
Related Commands
spanning-tree edge-port (510)