
Chapter 12
| Link Aggregation Commands
Trunk Status Display Commands
– 436 –
Console#show lacp 1 internal
Port Channel : 1
-------------------------------------------------------------------------
Oper Key : 3
Admin Key : 0
Timeout : long
Eth 1/ 1
-------------------------------------------------------------------------
LACPDUs Internal : 30 seconds
LACP System Priority : 32768
LACP Port Priority : 32768
Admin Key : 3
Oper Key : 3
Admin State : defaulted, aggregation, long timeout, LACP-activity
Oper State : distributing, collecting, synchronization,
aggregation, long timeout, LACP-activity
.
.
.
Table 79: show lacp internal - display description
Field
Description
Oper Key
Current operational value of the key for the aggregation port.
Admin Key
Current administrative value of the key for the aggregation port.
LACPDUs Internal
Number of seconds before invalidating received LACPDU information.
LACP System
Priority
LACP system priority assigned to this port channel.
LACP Port Priority
LACP port priority assigned to this interface within the channel group.
Admin State,
Oper State
Administrative or operational values of the actor’s state parameters:
◆
Expired – The actor’s receive machine is in the expired state;
◆
Defaulted – The actor’s receive machine is using defaulted operational
partner information, administratively configured for the partner.
◆
Distributing – If false, distribution of outgoing frames on this link is disabled;
i.e., distribution is currently disabled and is not expected to be enabled in
the absence of administrative changes or changes in received protocol
information.
◆
Collecting – Collection of incoming frames on this link is enabled; i.e.,
collection is currently enabled and is not expected to be disabled in the
absence of administrative changes or changes in received protocol
information.
◆
Synchronization – The System considers this link to be IN_SYNC; i.e., it has
been allocated to the correct Link Aggregation Group, the group has been
associated with a compatible Aggregator, and the identity of the Link
Aggregation Group is consistent with the System ID and operational Key
information transmitted.
◆
Aggregation – The system considers this link to be aggregatable; i.e., a
potential candidate for aggregation.
◆
Long timeout – Periodic transmission of LACPDUs uses a slow transmission
rate.
◆
LACP-Activity – Activity control value with regard to this link.
(0: Passive; 1: Active)
Summary of Contents for ECS4120-28F
