Edge-Core ECS4120-28F, Reference Manual, Page: 428 / 938

Chapter 12
| Link Aggregation Commands
Manual Configuration Commands
– 428 –
router trunk links where traffic through the switch is received from and
destined for many different hosts.
■
src-dst-mac : All traffic with the same source and destination MAC address
is output on the same link in a trunk. This mode works best for switch-to-
switch trunk links where traffic through the switch is received from and
destined for many different hosts.
■
src-ip : All traffic with the same source IP address is output on the same link
in a trunk. This mode works best for switch-to-router or switch-to-server
trunk links where traffic through the switch is received from many different
hosts.
■
src-mac : All traffic with the same source MAC address is output on the
same link in a trunk. This mode works best for switch-to-switch trunk links
where traffic through the switch is received from many different hosts.
Example
Console(config)#port-channel load-balance dst-ip
Console(config)#
channel-group
This command adds a port to a trunk. Use the no form to remove a port from a
trunk.
Syntax
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-26)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆
When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
◆
Use no channel-group to remove a port group from a trunk.
◆
Use no interface port-channel to remove a trunk from the switch.