Edge-Core ECS4120-28F, Reference Manual, Page: 291 / 938

Chapter 9
| General Security Measures
Network Access (MAC Address Authentication)
– 291 –
Command Usage
◆
The VLAN to be used as the guest VLAN must be defined and set as active (See
the
vlan database command).
◆
When used with 802.1X authentication, the intrusion-action must be set for
“guest-vlan” to be effective (see the
dot1x intrusion-action command).
◆
A port can only be assigned to the guest VLAN in case of failed authentication,
if
switchport mode is set to Hybrid.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access guest-vlan 25
Console(config-if)#
network-access
link-detection
Use this command to enable link detection for the selected port. Use the no form of
this command to restore the default.
Syntax
[ no ] network-access link-detection
Default Setting
Disabled
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection
Console(config-if)#