Edge-Core ECS4120-28F, Reference Manual, Page: 225 / 938

Chapter 8
| Authentication Commands
RADIUS Client
– 225 –
Default Setting
1813
Command Mode
Global Configuration
Example
Console(config)#radius-server acct-port 181
Console(config)#
radius-server
auth-port
This command sets the RADIUS server network port. Use the no form to restore the
default.
Syntax
radius-server auth-port port-number
no radius-server auth-port
port-number - RADIUS server UDP port used for authentication messages.
(Range: 1-65535)
Default Setting
1812
Command Mode
Global Configuration
Example
Console(config)#radius-server auth-port 181
Console(config)#
radius-server host
This command specifies primary and backup RADIUS servers, and authentication
and accounting parameters that apply to each server. Use the
no form to remove a
specified server, or to restore the default values.
Syntax
[ no ] radius-server index host host-ip-address [ acct-port acct-port ]
[ auth-port auth-port ] [ key key ] [ retransmit retransmit ] [ timeout timeout ]
index - Allows you to specify up to five servers. These servers are queried in
sequence until a server responds or the retransmit period expires.
host-ip-address - IP address of server.
acct-port - RADIUS server UDP port used for accounting messages.
(Range: 1-65535)