Edge-Core ECS4120-28F, Reference Manual, Page: 207 / 938

Chapter 6
| Remote Monitoring Commands
– 207 –
◆
The information collected for each sample includes:
input octets, packets, broadcast packets, multicast packets, undersize packets,
oversize packets, fragments, jabbers, CRC alignment errors, collisions, drop
events, and network utilization.
◆
The switch reserves two controlEntry index entries for each port. If a default
index entry is re-assigned to another port by this command, the
show running-
config command will display a message indicating that this index is not
available for the port to which is normally assigned.
For example, if control entry 15 is assigned to port 5 as shown below, the show
running-config command will indicate that this entry is not available for port
8.
Console(config)#interface ethernet 1/5
Console(config-if)#rmon collection history controlEntry 15
Console(config-if)#end
Console#show running-config
!
interface ethernet 1/5
rmon collection history controlEntry 15 buckets 50 interval 1800
...
interface ethernet 1/8
no rmon collection history controlEntry 15
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rmon collection history controlentry 21 owner mike
buckets 24 interval 60
Console(config-if)#
rmon collection
rmon1
This command enables the collection of statistics on a physical interface. Use the
no form to disable statistics collection.
Syntax
rmon collection rmon1 controlEntry index [ owner name ]
no rmon collection rmon1 controlEntry index
index – Index to this entry. (Range: 1-65535)
name – Name of the person who created this entry.
(Range: 1-32 characters)
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)