Edge-Core ECS4110-28T, Management Manual, Page: 787 / 1514

C
HAPTER
21
| System Management Commands
Switch Clustering
– 787 –
to the Commander. When using a console connection, from the
Commander CLI prompt, use the rcommand to connect to the Member
switch.
cluster
This command enables clustering on the switch. Use the no form to disable
clustering.
S
YNTAX
[ no ] cluster
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
To create a switch cluster, first be sure that clustering is enabled on the
switch (the default is enabled), then set the switch as a Cluster
Commander. Set a Cluster IP Pool that does not conflict with any other
IP subnets in the network. Cluster IP addresses are assigned to
switches when they become Members and are used for communication
between Member switches and the Commander.
◆
Switch clusters are limited to the same Ethernet broadcast domain.
◆
There can be up to 100 candidates and 36 member switches in one
cluster.
◆
A switch can only be a Member of one cluster.
◆
Configured switch clusters are maintained across power resets and
network changes.
E
XAMPLE
Console(config)#cluster
Console(config)#
cluster commander
This command enables the switch as a cluster Commander. Use the no
form to disable the switch as cluster Commander.
S
YNTAX
[ no ] cluster commander
D
EFAULT
S
ETTING
Disabled