Edge-Core ECS4110-28T, Management Manual, Page: 1363 / 1514

C
HAPTER
42
| CFM Commands
Defining CFM Structures
– 1363 –
show ethernet cfm
maintenance-points
local
This command displays the maintenance points configured on this device.
S
YNTAX
show ethernet cfm maintenance-points local
{ mep [ domain domain-name | interface interface |
level level-id ] | mip [ domain domain-name | level level-id ]}
mep – Displays only local maintenance end points.
mip – Displays only local maintenance intermediate points.
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
interface – Displays CFM status for the specified interface.
ethernet unit / port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
level-id – Maintenance level for this domain. (Range: 0-7)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
◆
Use the mep keyword with this command to display the MEPs
configured on this device as DSAPs through the ethernet cfm mep
command.
◆
Using the mip keyword with this command to display the MIPs
generated on this device by the CFM protocol when the mip-creation
method is set to either “default” or “explicit” by the ethernet cfm
domain command or the ma index name command.
E
XAMPLE
This example shows all MEPs configured on this device for maintenance
domain rd.
Console#show ethernet cfm maintenance-points local mep
MPID MD Name Level Direct VLAN Port CC Status MAC Address
---- ---------------- ----- ------ ---- -------- --------- -----------------
1 rd 0 UP 1 Eth 1/ 1 Enabled 00-12-CF-3A-A8-C0
Console#