Edge-Core ECS4110-28T, Management Manual, Page: 1327 / 1514

C
HAPTER
41
| LLDP Commands
– 1327 –
◆
Information about changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the
time of a notification are included in the transmission. An SNMP agent
should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
E
XAMPLE
Console(config)#lldp notification-interval 30
Console(config)#
lldp refresh-interval
This command configures the periodic transmit interval for LLDP
advertisements. Use the no form to restore the default setting.
S
YNTAX
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP
advertisements are sent. (Range: 5 - 32768 seconds)
D
EFAULT
S
ETTING
30 seconds
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
Console(config)#lldp refresh-interval 60
Console(config)#
lldp reinit-delay
This command configures the delay before attempting to re-initialize after
LLDP ports are disabled or the link goes down. Use the no form to restore
the default setting.
S
YNTAX
lldp reinit-delay seconds
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP.
(Range: 1 - 10 seconds)
D
EFAULT
S
ETTING
2 seconds