Edge-Core ECS3810-26T, Installation Manual, Page: 40 / 76

C
HAPTER
2
| Installing the Switch
Connecting to a Power Source
– 40 –
10.
Check the the PWR LED indicator as the switch is powered on. If not,
recheck the power supply and power cable connections at the supply source
and at power conversion module.
C
ONNECTING
AC P
OWER
To connect the switch to an AC power source:
1.
First verify that the external AC power supply can provide 100 to 240 VAC,
50-60 Hz, 0.33 A minimum.
2.
Plug the power cable into a grounded, 3-pin, AC power source.
3.
Insert the plug on the other end of the power cable directly into the socket
on the switch.
Figure 12: AC Power Socket
4.
After the power source is connected, set the power switch on the front of
the switch to the ON position (marked “–”).
N
OTE
:
For international use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the socket type
in your country.
AC Power Receptacle