Edge-Core ECS3510-28F, Installation Manual, Page: 40 / 72

C
HAPTER
3
| Installing the Switch
Connecting to a Power Source
– 40 –
3.
Slide the SFP transceiver into the slot until it clicks into place.
C
ONNECTING TO A
P
OWER
S
OURCE
To connect a switch to a power source:
1.
Insert the power cable plug directly into the AC socket located at the back of
the switch.
Figure 12: Power Socket
2.
Plug the other end of the cable into a grounded, 3-pin, AC power source.
3.
Check the front-panel LEDs as the device is powered on to be sure the
Power LED is lit. If not, check that the power cable is correctly plugged in.
4.
If you have purchased a Redundant Power Unit, connect it to the switch and
to an AC power source now, following the instructions included with the
package.
N
OTE
:
SFP transceivers are hot-swappable. The switch does not need to
be powered off before installing or removing a transceiver. However,
always first disconnect the network cable before removing a
transceiver.
N
OTE
:
SFP transceivers are not provided in the switch package.
N
OTE
:
For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the socket type
in your country.