Edge-Core ECS3510-28F, Installation Manual, Page: 27 / 72

C
HAPTER
1
| Introduction
Description of Hardware
– 27 –
Table 1: 100 Mbps SC Port Status LEDs (1~24)
LED Condition Status
Link/Act On/Flashing Green Port has established a valid 100 Mbps network
connection. Flashing indicates activity.
Off There is no valid link on the port.
Table 2: 1000 Mbps Combination RJ-45/SFP Ports Status LEDs (25~28)
LED Condition Status
25~28
(Link/Activity)
On/Flashing Green Port has established a valid 1000 Mbps network
connection. Flashing indicates activity.
On/Flashing Amber Port has established a valid 10/100 Mbps network
connection. Flashing indicates activity.
Off There is no valid link on the port.
Table 3: System Status LEDs
LED Condition Status
Power On Green The unit’s internal power supply is operating
normally.
On Amber The unit has an internal power supply fault.
Off The unit has no power connected.
Diag On Green The system diagnostic test has completed
successfully.
Flashing Green The system diagnostic test is in progress.
On Amber Indicates one of the following:
◆ After powering on, indicates that the system
diagnostic test has detected a fault.
◆ During operation, indicates that an installed
SFP transceiver has failed.
RPS On Green An RPU is connected and operating normally.
On Amber A fault has been detected in a connected RPU.
TS1000 On Green A TS1000 optional converter module is installed.
On Amber A TS1000 optional converter module is not
installed