Edge-Core AS5700-54X, Cli Reference Manual, Page: 973 / 1116

Chapter 29
| IP Routing Commands
Border Gateway Protocol (BGPv4)
– 973 –
hold-time – The maximum interval after which a neighbor is declared dead
if a keep-alive or update message has not been received. (Range: 0-65535
seconds)
Command Mode
Router Configuration
Default Setting
Keep Alive time: 60 seconds
Hold time: 180 seconds
Command Usage
◆
This command sets the Keep Alive time used for maintaining connectivity, and
the Hold time to wait for Keep Alive or Update messages before declaring a
neighbor down.
◆
This command sets timers for monitoring connectivity to specific neighboring
routers, which supercede those applied to all neighbors with the global
timers
bgp command.
Example
Console(config-router)#neighbor 10.1.1.66 timers 50 200
Console(config-router)#
neighbor timers
connect
This command sets the time to wait before attempting to reconnect to a neighbor
whose TCP connection has failed. Use the
no form to restore the default setting.
Syntax
[ no ] neighbor ip-address timers connect retry-interval
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring routers
configured with the neighbor peer-group command.
retry-interval – The amount of time the system waits for the transport
protocol connection to complete. If this timer expires, the state remains in
Connect state, the timer is reset, and the system tries to initiate a new
transport connection. (Range: 0-65535 seconds)
Command Mode
Router Configuration
Default Setting
120 seconds