Edge-Core AS5700-54X, Cli Reference Manual, Page: 824 / 1116

Chapter 29
| IP Routing Commands
Routing Information Protocol (RIP)
– 824 –
Command Mode
Router Configuration
Command Usage
All the learned RIP routes may not be copied to the hardware tables in ASIC for fast
data forwarding because of hardware resource limitations.
Example
Console(config-router)#maximum-prefix 1024
Console(config-router)#
neighbor
This command defines a neighboring router with which this router will exchange
routing information. Use the
no form to remove an entry.
Syntax
[ no ] neighbor ip-address
ip-address - IP address of a neighboring router.
Default Setting
No neighbors are defined.
Command Mode
Router Configuration
Command Usage
◆
This command can be used to configure a static neighbor (specifically for point-
to-point links) with which this router will exchange routing information, rather
than relying on broadcast or multicast messages generated by the RIP protocol.
◆
Use this command in conjunction with the passive-interface command to
control the routing updates sent to specific neighbors.
Example
Console(config-router)#neighbor 10.2.0.254
Console(config-router)#
Related Commands
passive-interface (826)