Edge-Core AS5700-54X, Cli Reference Manual, Page: 659 / 1116

Chapter 23
| LLDP Commands
– 659 –
Command Usage
◆
The transmit delay is used to prevent a series of successive LLDP transmissions
during a short period of rapid changes in local LLDP MIB objects, and to
increase the probability that multiple, rather than single changes, are reported
in each transmission.
◆
This attribute must comply with the following rule:
(4 * tx-delay)
≤
refresh-interval
Example
Console(config)#lldp tx-delay 10
Console(config)#
lldp admin-status
This command enables LLDP transmit, receive, or transmit and receive mode on the
specified port. Use the
no form to disable this feature.
Syntax
lldp admin-status { rx-only | tx-only | tx-rx }
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#
lldp basic-tlv
management-ip-
address
This command configures an LLDP-enabled port to advertise the management
address for this device. Use the
no form to disable this feature.
Syntax
[ no ] lldp basic-tlv management-ip-address
Default Setting
Enabled