Edge-Core AS5700-54X, Cli Reference Manual, Page: 378 / 1116

Chapter 10
| Interface Commands
Transceiver Threshold Configuration
– 378 –
Transceiver Threshold Configuration
transceiver-threshold-
auto
This command uses default threshold settings obtained from the transceiver to
determine when an alarm or warning message should be sent. Use the
no form to
disable this feature.
Syntax
transceiver-threshold-auto
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold-auto
Console#
Table 71: show interfaces switchport - display description
Field Description
Broadcast
Threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (
page 421 ).
Multicast Threshold Shows if multicast storm suppression is enabled or disabled; if enabled it also
shows the threshold level ( page 421 ).
Unknown Unicast
Threshold Shows if unknown unicast storm suppression is enabled or disabled; if enabled
it also shows the threshold level (
page 421 ).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(
page 393 ).
VLAN Membership
Mode Indicates membership mode as Trunk or Hybrid ( page 479 ).
Ingress Rule Shows if ingress filtering is enabled or disabled ( page 478 ).
Acceptable Frame
Type Shows if acceptable VLAN frames include all types or tagged frames only
(
page 475 ).
Native VLAN Indicates the default Port VLAN ID ( page 480 ).
Priority for
Untagged Traffic Indicates the default priority for untagged frames ( page 510 ).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (
page 476 ).