Edge-Core AS5700-54X, Cli Reference Manual, Page: 303 / 1116

Chapter 8
| General Security Measures
IPv4 Source Guard
– 303 –
ip source-guard
binding
This command adds a static address to the source-guard ACL or MAC address
binding table. Use the
no form to remove a static entry.
Syntax
ip source-guard binding [ mode { acl | mac }] mac-address
vlan vlan-id ip-address interface ethernet unit/port-list
no ip source-guard binding [ mode { acl | mac }] mac-address vlan vlan-id
mode - Specifies the binding mode.
acl - Adds binding to ACL table.
mac - Adds binding to MAC address table.
mac-address - A valid unicast MAC address.
vlan-id - ID of a configured VLAN for an ACL filtering table or a range of
VLANs for a MAC address filtering table. To specify a list separate
nonconsecutive VLAN identifiers with a comma and no spaces; use a
hyphen to designate a range of IDs. (Range: 1-4094)
ip-address - A valid unicast IP address, including classful types A, B or C.
unit - Unit identifier. (Range: 1)
port-list - Physical port number or list of port numbers. Separate
nonconsecutive port numbers with a comma and no spaces; or use a
hyphen to designate a range of port numbers. (Range: 1-28/52)
Default Setting
No configured entries
Command Mode
Global Configuration
Command Usage
◆
If the binding mode is not specified in this command, the entry is bound to the
ACL table by default.
◆
Table entries include a MAC address, IP address, lease time, entry type (Static-IP-
SG-Binding, Dynamic-DHCP-Binding), VLAN identifier, and port identifier.
◆
All static entries are configured with an infinite lease time, which is indicated
with a value of zero by the
show ip source-guard command ( page 308 ).
show ip source-guard Shows whether source guard is enabled or disabled on
each interface PE
show ip source-guard
binding Shows the source guard binding table PE
Table 57: IPv4 Source Guard Commands
Command Function Mode