Edge-Core AS5700-54X, Cli Reference Manual, Page: 1019 / 1116

Chapter 30
| Multicast Routing Commands
Static Multicast Routing
– 1019 –
This example lists all entries in the multicast table in summary form:
Console#show ipv6 mroute summary
IP Multicast Forwarding is disabled
IP Multicast Routing Table (Summary)
Flags: F - Forwarding, P - Pruned, D - PIM-DM, S – PIM-SM, V – DVMRP,
M - MLD
Group Source Interface Flag
------------------------------ ------------------------------ ---------- ----
FF02::0101 FE80::0101 VLAN 4096 DF
Total Entry is 1
Console#
Static Multicast Routing
This section describes commands used to configure static multicast routes on the
switch.
ip igmp snooping vlan
mrouter
This command statically configures a multicast router port. Use the no form to
remove the configuration.
Syntax
ip igmp snooping vlan vlan-id mrouter interface
no ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit / port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
Default Setting
No static multicast router ports are configured.
Table 197: Static Multicast Routing Commands
Command Function Mode
ip igmp snooping vlan
mrouter Adds a multicast router port GC
show ip igmp snooping
mrouter Shows multicast router ports PE