310003_04 | 06.2019
Eder Forestrytools
40
EN
To remove the dust from the filter surface:
>
Gently tap one corner of the air filter against a solid surface.
To remove the dirt from the inside:
>
Open the air filter in the middle.
>
Brush the air filter with a benzine soaked brush or clean it
with compressed air.
To reassemble the device:
>
Reassemble the parts in the reverse order.
Changing the carburettor filter
To keep the drive motor in good working order, you must change the
carburettor filter (
1
) once a year.
>
Empty the tank.
>
Remove the carburettor filter (
1
) from the tank using a hook
or long nose pliers.
Adjusting the carburettor
>
The carburettor was adjusted at the factory.
>
Before adjusting the carburettor, check that the air filters are
clean. Otherwise, you will not be able to adjust the
carburettor correctly.
ATTENTION
Damage to the carburettor!
If you overtighten the maximum speed adjustment screw (
H
) or the
idle speed adjustment screw (
L
) of the carburettor (see Fig. 20 and
Fig. 21), the carburettor will be damaged.
Tighten the adjusting screws only slightly.
