©2008 Edelbrock Corporation
Brochure #63-70067
Catalog #70067 & 70068
Rev. 6/08 AJ/mc
Page 1 of 2
Important: The wiring hardware and instructions included with this kit are intended for 12-volt electrical systems only. Before
attempting to wire your Edelbrock Performer nitrous oxide system, examine and follow the wiring diagram on the following page.
Please call the Edelbrock Technical department with any questions concerning electrical wiring.
Item # Quantity
Description
1
1
Activation Micro Switch
2
2
Activation Micro Switch Mounting Nut
3
2
Activation Micro Switch Mounting Bolt
4
1
30 amp Relay
5
1
Wire Harness with Integral Relay/Fuse Holder
6
1
Red Lighted Toggle Switch
7
2
18/22g Female Spade Connector
8
2
14/16g Female Spade Connector
9
2
14/16g Male Spade Connector
10
2
16/18g Splice Connector
11
1
3/8” Ring Terminal
12
2
18/22g Ring Terminal #8 Stud
13
1
18/22g Ring Terminal #10 Stud
14
1
14/16g Male Spade Connector
15
1
Pushbutton
1
2
3
4
5
15
6
10
10
9
8
14
13
7
12
11
ELECTRICAL COMPONENTS BILL OF MATERIAL
1st Stage Nitrous Jet #1
1st Stage Nitrous Jet #2
1st Stage Fuel Jet #1
1st Stage Fuel Jet #2
2nd Stage
Nitrous
Jet #2
2nd Stage
Nitrous
Jet #1
2nd Stage
Fuel Jet #1
2nd Stage
Fuel Jet #2
Front of Engine
1st Stage Bar
2nd Stage Bar
HP Gain N2O Jet Fuel Jet Timing Adj.
100hp
35
35
3°-5° Retard
150hp
50
50
5°-7° Retard
200hp
59
59
7°-9° Retard
250hp
68
68
9°-11° Retard
Total Gain
Timing Adj.
200hp
7°-9° Retard
300hp
11°-13° Retard
400hp
15°-17° Retard
500hp
19°-21° Retard
1st Stage
2nd Stage
Dominator-Flange 2-Stage Jet Map
Square-Flange 2-Stage Jet Map
2-STAGE VICTOR JR.
UPGRADE KIT
(P/N 70067-70068)
Dyno testing was conducted using a mildly modified 500ci engine.
Modifications included an Edelbrock intake manifold, dyno headers and
improved ignition. These tests were conducted using 950 psi of bottle
pressure and 6.5 psi of fuel pressure. Suggested timing is just a guide-
line, engine component modifications may affect final timing set point.
Edelbrock suggests an NGK spark plug with a heat range between -9 and
-11 as well as 110 octane or higher race fuel.
The Victor Jr. Series Nitrous Systems are intended for use with
single plain intake manifolds only.
Your upgrade kit comes supplied with longer 6AN lines to split from the
feed line to the solenoids, and longer lines to extend from the solenoids to
the plate.
Note:
It is important to route the 3AN to 4AN hoses to jet fittings in such
a manner that the 1st stage jetting feeds a spray bar from opposing ends
of the plate while the 2nd stage jetting feeds from opposing ends of the
plate 90 degrees apart from the 1st stage. See the diagram at left for a
sample recommended installation.
HP Gain N2O Jet Fuel Jet
100hp
35
35
150hp
50
50
200hp
59
59
250hp
68
68
Final Timing
HP Gain N2O Jet Fuel Jet Timing Adj.
100hp
35
35
3°-5° Retard
150hp
48
48
5°-7° Retard
200hp
57
57
7°-9° Retard
250hp
66
66
9°-11° Retard
Total Gain
Timing Adj.
200hp
7°-9° Retard
300hp
11°-13° Retard
400hp
15°-17° Retard
500hp
19°-21° Retard
1st Stage
2nd Stage
HP Gain N2O Jet Fuel Jet
100hp
35
35
150hp
48
48
200hp
57
57
250hp
66
66
Final Timing
